The handlebar is designed for use on ROTAX-powered engines, which means that cable excursions have been designed for perfect compatibility with standard mounted carburettors.

Made of ergal, lightweight, fully machined CNC

The set includes 3 levers:

– Gas (throttle)

– Trim

– Air (choke)

There is a cable splitter for gas control and air control.

The trim lever features two mechanical (non-push-pull) safety cables, which actuate the flap and return feedback on the position of the flap in a simple and immediate way.

The set is customizable and can, on request, also be available without the lever.

For Tandem aircraft, the gas clamp can be coupled to a second clamp that is mounted in the rear seat reserved for the passenger or instructor.

The gas handle has a start button and two buttons to adjust the pitch of the electric propeller. (HOTAS philosophy – hand on throttle and stick, hands on handle and bar).

The pilot can adjust the hardness of the handcuffs controls by means of a special clutch placed in the center of the pivot; is therefore completely customizable for maximum driving comfort.

To simplify the activity of the rider, the handle of the Trim has been differentiated (knurled and anodized red) to distinguish it without any difficulty, at a glance and at the touch, from the air. (Chocke)

In order to facilitate installation, the full flange is supplied already mounted on a suitable aluminum plate, easy to apply on the aircraft.

The cable sheaths are held in position by 4 registers, for the adjustment to the carburettors.

The registers comprise a device that blocks the sheath, preventing it from sliding out of the housings.

The gas has an autonomous IDLE adjustment, so it does not stress the control cables.

All surfaces are subjected to a hard chrome anodizing process, followed by a porous sealing treatment for better surface wear.

Weight: 1060gr